| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: fix dma_buffer leak on bus acquire failure
wilc_wlan_firmware_download() allocates dma_buffer with kmalloc() at
the top of the function and uses a 'fail:' label to free it via
kfree(dma_buffer) on error.
All later error paths correctly use 'goto fail' to route through this
cleanup. However, the early failure path after the first acquire_bus()
call uses a bare 'return ret;', which leaks dma_buffer whenever the bus
acquire fails.
Replace the early return with goto fail so the existing cleanup path
runs.
Found via a custom Coccinelle semantic patch hunting for kmalloc'd
locals leaked on early-return error paths in driver firmware-download
code. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: bound copy_lcns dp->page_lcns[] index in analysis pass
In log_replay()'s analysis pass, after find_dp() returns a
valid DIR_PAGE_ENTRY for the (target_attr, target_vcn) tuple,
the copy_lcns block walks lrh->lcns_follow further entries:
t16 = le16_to_cpu(lrh->lcns_follow);
for (i = 0; i < t16; i++) {
size_t j = (size_t)(le64_to_cpu(lrh->target_vcn) -
le64_to_cpu(dp->vcn));
dp->page_lcns[j + i] = lrh->page_lcns[i];
}
find_dp() only validates that target_vcn falls within
[dp->vcn, dp->vcn + dp->lcns_follow), i.e., that the FIRST
cluster is covered. The walk through the further entries is
not bounded against dp->lcns_follow. For a malformed LRH
where target_vcn = dp->vcn + dp->lcns_follow - 1 and
lrh->lcns_follow > 1, the i > 0 writes overflow the dp's
allocated page_lcns[] array.
Add the missing j + lrh->lcns_follow <= dp->lcns_follow guard.
Reproduced under UML+KASAN on mainline 8d90b09e6741 as a
slab-out-of-bounds write of size 8 from log_replay+0x68d4 on
the mount path.
This is distinct from Pavitra Jha's 2026-05-02 patch
("fs/ntfs3: validate lcns_follow in log_replay conversion",
<20260502154252.164586-1-jhapavitra98@gmail.com>) which
addresses the separate version-0 dirty-page-table conversion
path's memmove(&dp->vcn, ...) call. The two fixes are
complementary; both should land.
[almaz.alexandrovich@paragon-software.com: clang-formatted the changes,
fixed conflicts] |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: validate index entries on reading
Validate index entries immediately after reading an index root or index
block from disk. This eliminates repeated checks in lookup and readdir,
and reduce the risk of missing checks in those paths. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: prevent TVLV OOB check overflow
A TT unicast TVLV contains the number of VLANs stored in it. This number is
an u16 and gets multiplied by the size of the struct
batadv_tvlv_tt_vlan_data (8 bytes). The size can therefore overflow the u16
used to store the tt_vlan_len. All additional safety checks to prevent
out-of-bounds access of the TVLV buffer are invalid due to this overflow.
Using size_t prevents this overflow and ensures that the safety checks
compare against the actual buffer requirements. |
| OP-TEE OS through 4.10.0, fixed in commit 7b8b494, contains a buffer underwrite vulnerability in the RSA NOPAD encrypt and decrypt operations within the mbedTLS software backend and SE050 hardware driver that allows a malicious Trusted Application to corrupt secure-world heap memory by supplying an input length exceeding the RSA modulus size. When src_len exceeds rsa_len, the subtraction expression wraps to a large unsigned value, causing a subsequent memcpy to write attacker-controlled data before the destination buffer in S-EL1 secure-world heap memory. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_set_pipapo: don't leak bad clone into future transaction
On memory allocation failure the cloned nft_pipapo_match can enter a bad
state:
- some fields can have their lookup tables resized while others did
not
- bits might have been toggled
- scratch map can be undersized which also means m->bsize_max can be
lower than what is required
This means that the next insertion in the same batch can trigger
out-of-bounds writes.
Furthermore, a failure in the first can result in the bad clone to
leak into the next transaction because the abort callback is never
executed in this case (the upper layer saw an error and no attempt to
allocate a transactional request was made).
Record a state for the nft_pipapo_match structure:
- NEW (pristine clone)
- MOD (modified clone with good state)
- ERR (potentially bogus content)
Then make it so that deletes and insertions fail when the clone
entered ERR state.
In case the very first insert attempt results in an error, free the
clone right away. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: nv: Inject SEA if guest VNCR isn't normal memory
When constructing an L1 VNCR mapping, KVM unconditionally uses cacheable
memory attributes, even if the underlying PFN isn't memory. This gets
particularly hairy if the endpoint doesn't support cacheable memory
attributes, potentially throwing an SError on writeback...
While KVM does permit cacheable memory attributes on certain PFNMAP
VMAs, kvm_translate_vncr() isn't currently grabbing the VMA. So do the
simpler thing for now and just reject everything that isn't memory. |
| In the Linux kernel, the following vulnerability has been resolved:
qede: fix off-by-one in BD ring consumption on build_skb failure
qede_rx_build_skb() and qede_tpa_rx_build_skb() do not check for a
NULL return from qede_build_skb(). When it returns NULL under memory
pressure, the functions still consume a BD from the ring before
returning NULL. The callers then recycle additional BDs, resulting in
one extra BD being consumed (off-by-one). This desynchronizes the BD
ring, which can corrupt DMA page reference counts and lead to SLUB
freelist corruption.
Commit 4e910dbe3650 ("qede: confirm skb is allocated before using")
added a NULL check inside qede_build_skb() to prevent a NULL pointer
dereference, but did not address the missing NULL checks in the
callers, making this off-by-one reachable.
Fix this by adding NULL checks for the return value of
qede_build_skb() in both qede_rx_build_skb() and
qede_tpa_rx_build_skb(), returning NULL immediately before any BD ring
manipulation. |
| HP has identified a potential vulnerability in HP Web Jetadmin (WJA) that may allow an unauthenticated actor to read from or write to arbitrary files through a DLL hijacking mechanism. |
| In the Linux kernel, the following vulnerability has been resolved:
xen/pvcalls: bound backend response req_id before indexing rsp[]
pvcalls_front_event_handler() takes req_id directly from the
backend-supplied ring response and uses it to index the fixed-size
bedata->rsp[] array for a memcpy() and a store, with no range check. A
malicious or buggy backend can set req_id past PVCALLS_NR_RSP_PER_RING
and drive an out-of-bounds write past the bedata allocation.
req_id was also declared int while the wire field rsp->req_id is u32, so
a range check on the signed value alone is insufficient: a backend
req_id of 0xffffffff becomes -1, passes a >= PVCALLS_NR_RSP_PER_RING
test and indexes bedata->rsp[-1]. Declare req_id as u32 so a single
bound covers both ends.
A backend that sends an out-of-range req_id has violated the wire
protocol, so rather than silently dropping the response, log once and
stop trusting the backend: set bedata->disabled. The event handler then
ignores further responses, and the request paths that wait for a
response return -EIO instead of blocking forever. This mirrors the
fatal-error handling xen-netback uses (xenvif_fatal_tx_err()).
The pvcalls frontend currently trusts its backend, so this is not a
classic-Xen security issue, but it matters for hardening PV frontends
against malicious backends (confidential and disaggregated deployments). |
| The Zephyr ADIN2111/ADIN1110 10BASE-T1S/T1L Ethernet driver (drivers/ethernet/eth_adin2111.c) reassembles received Ethernet frames in OPEN Alliance (OA) SPI mode by copying device-supplied 64-byte data chunks into a fixed static buffer ctx->buf of size CONFIG_ETH_ADIN2111_BUFFER_SIZE (default 1524 bytes). In eth_adin2111_oa_data_read(), each valid chunk was memcpy'd into ctx->buf[ctx->scur] and the write cursor scur advanced, with no check that scur + len stayed within the buffer. The number of chunks (up to 255, from the BUFSTS RCA field) and the per-chunk length are taken entirely from the frame data received off the wire; the cursor is only reset on a start-of-frame chunk. An attacker on the single-pair Ethernet segment can therefore send a frame whose reassembled size exceeds the configured buffer, causing the driver's RX offload thread to write attacker-controlled frame bytes past the end of the static buffer into adjacent driver/kernel memory (up to roughly 14.8 KB in the worst case). This is a remotely/adjacently reachable out-of-bounds write (CWE-787) that can corrupt memory and cause denial of service or potentially code execution. The defect was introduced when OA SPI support was added (commit 0ca8b0756b1) and shipped in releases v3.7.0 through v4.4.0. The fix adds a bounds check that drops the oversized frame and resets the cursor before the copy. |
| The WNC-M14A2A LTE-M modem driver mishandles unsolicited %NOTIFYEV: events in on_cmd_socknotifyev() (drivers/modem/vendor_standalone/wncm14a2a.c). The response line is linearized into a fixed 40-byte stack buffer via net_buf_linearize(), which caps the copy at 39 bytes and returns out_len <= 39. The two quote-delimiter scanning loops, however, were bounded by len — the full CR/LF-delimited frame length returned by net_buf_findcrlf() — rather than by out_len.
When a %NOTIFYEV: line longer than 39 bytes contains no " within the linearized region, the loop indices p1/p2 walk past value[39] and read adjacent stack memory until a stray quote byte is found or the index reaches len. The over-read string is then passed to strncmp()/atoi()/LOG_*, and if a quote byte is found out of bounds the subsequent value[p2] = '\0' performs a single-NUL out-of-bounds stack write at an attacker-influenced offset.
The %NOTIFYEV: payload carries network-derived content (LTIME network time, SIB1 base-station system information, CSPS/RRCSTATE), so a rogue cellular base station, a malicious or compromised modem module, or RF manipulation that induces an over-long notify line reaches the defect without any application interaction; the handler runs automatically on the unsolicited event in the modem RX thread.
The impact is out-of-bounds stack disclosure (into logs and parsing) and stack corruption that can crash the modem RX thread (denial of service). The write offset is only weakly controlled, so memory-safe code execution is not demonstrated. The fix bounds both scanning loops by out_len, keeping all accesses within the linearized buffer. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: validate index block header more strictly
Modify ntfs_index_block_inconsisent() to perform stricter validation of
INDEX_HEADER geometry in INDX blocks, and update
ntfs_lookup_inode_by_name() to use that function to validate INDX
blocks. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote authenticated attacker to cause a denial of service due to a stack-based buffer overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
sctp: add INIT verification after cookie unpacking
In SCTP handshake, the INIT chunk is initially processed by the server
and embedded into the cookie carried in INIT-ACK. The client then
returns this cookie via COOKIE-ECHO, where the server unpacks it and
reconstructs the original INIT chunk.
When cookie authentication is enabled, the cookie contents are protected
against tampering, so reusing the unpacked INIT without re-verification
is safe.
However, when cookie authentication is disabled, the reconstructed INIT
can no longer be trusted. In this case, the INIT must be explicitly
validated after unpacking to avoid processing potentially tampered data.
Add sctp_verify_init() checks after cookie unpacking in COOKIE-ECHO
processing paths (sctp_sf_do_5_1D_ce() and sctp_sf_do_5_2_4_dupcook())
when cookie_auth_enable is disabled. On failure, the new association is
freed and the packet is discarded.
Also tighten cookie validation in sctp_unpack_cookie() by verifying the
embedded chunk type is SCTP_CID_INIT before treating it as an INIT
chunk.
Finally, update sctp_verify_init() to validate parameter bounds using
the actual embedded INIT length instead of chunk->chunk_end, since the
INIT stored in COOKIE-ECHO may not span the entire chunk buffer. |
| Out-of-bounds write in Windows DNS allows an unauthorized attacker to execute code over an adjacent network. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote authenticated attacker to execute arbitrary code due to a heap-based buffer overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: xilinx-ams: fix out-of-bounds channel lookup in event handling
ams_event_to_channel() may return a pointer past the end of
dev->channels when no matching scan_index is found. This can lead
to invalid memory access in ams_handle_event().
Add a bounds check in ams_event_to_channel() and return NULL when
no channel is found. Also guard the caller to safely handle this
case. |
| In the Linux kernel, the following vulnerability has been resolved:
soundwire: fix bug in sdw_add_element_group_count found by syzkaller
The original implementation caused an out-of-bounds memory access
in the sdw_add_element_group_count for-loop when i == num.
for (i = 0; i <= num; i++) {
if (rate == group->rates[i] && lane == group->lanes[i])
...
To fix this error, the function now checks for existing rate/lane
entries in the group(a function parameter) using a for-loop before
adding them.
No functional changes apart from this fix. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a local attacker to execute arbitrary code due to an out-of-bounds write. |
