| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the Image Signature Verification feature of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker with administrator-level credentials to install a malicious software patch on an affected device. The vulnerability is due to improper verification of digital signatures for patch images. An attacker could exploit this vulnerability by crafting an unsigned software patch to bypass signature checks and loading it on an affected device. A successful exploit could allow the attacker to boot a malicious software patch image. |
| Multiple vulnerabilities in the web-based management interface of Cisco Firepower Management Center (FMC) Software could allow an authenticated, remote attacker to execute arbitrary commands on the underlying operating system. To exploit these vulnerabilities, the attacker must have valid device credentials, but does not need Administrator privileges. These vulnerabilities are due to insufficient validation of user-supplied input for certain configuration options. An attacker could exploit these vulnerabilities by using crafted input within the device configuration GUI. A successful exploit could allow the attacker to execute arbitrary commands on the device, including on the underlying operating system, which could also affect the availability of the device. |
| A vulnerability in the HTTP traffic filtering component of Cisco Firepower Threat Defense Software, Cisco FirePOWER Services Software for ASA, and Cisco Firepower Management Center Software could allow an unauthenticated, remote attacker to bypass filtering protections. The vulnerability is due to improper handling of HTTP requests, including those communicated over a secure HTTPS connection, that contain maliciously crafted headers. An attacker could exploit this vulnerability by sending malicious requests to an affected device. An exploit could allow the attacker to bypass filtering and deliver malicious requests to protected systems, allowing attackers to deliver malicious content that would otherwise be blocked. |
| A vulnerability in the password change feature of Cisco Firepower Management Center (FMC) software could allow an unauthenticated, remote attacker to determine valid user names on an affected device.
This vulnerability is due to improper authentication of password update responses. An attacker could exploit this vulnerability by forcing a password reset on an affected device. A successful exploit could allow the attacker to determine valid user names in the unauthenticated response to a forced password reset. |
| A vulnerability in the web-based management interface of Cisco Firepower Management Center (FMC) Software could allow an unauthenticated, remote attacker to conduct a cross-site scripting (XSS) attack against a user of the interface of an affected device. This vulnerability is due to insufficient validation of user-supplied input by the web-based management interface. An attacker could exploit this vulnerability by inserting crafted input into various data fields in an affected interface. A successful exploit could allow the attacker to execute arbitrary script code in the context of the interface, or access sensitive, browser-based information. |
| Multiple vulnerabilities in the Server Message Block (SMB) Protocol preprocessor detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent or remote attacker to cause a denial of service (DoS) condition. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the configuration of the Pluggable Authentication Module (PAM) used in Cisco Firepower Threat Defense (FTD) Software, Cisco Firepower Management Center (FMC) Software, and Cisco FXOS Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition. The vulnerability is due to improper resource management in the context of user session management. An attacker could exploit this vulnerability by connecting to an affected system and performing many simultaneous successful Secure Shell (SSH) logins. A successful exploit could allow the attacker to exhaust system resources and cause the device to reload, resulting in a DoS condition. To exploit this vulnerability, the attacker needs valid user credentials on the system. |
| A vulnerability in the protocol detection component of Cisco Firepower Threat Defense Software, Cisco FirePOWER Services Software for ASA, and Cisco Firepower Management Center Software could allow an unauthenticated, remote attacker to bypass filtering protections. The vulnerability is due to improper detection of the initial use of a protocol on a nonstandard port. An attacker could exploit this vulnerability by sending traffic on a nonstandard port for the protocol in use through an affected device. An exploit could allow the attacker to bypass filtering and deliver malicious requests to protected systems that would otherwise be blocked. Once the initial protocol flow on the nonstandard port is detected, future flows on the nonstandard port will be successfully detected and handled as configured by the applied policy. |
| A vulnerability in the implementation of the Lua interpreter integrated in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to execute arbitrary code with root privileges on the underlying Linux operating system of an affected device. The vulnerability is due to insufficient restrictions on the allowed Lua function calls within the context of user-supplied Lua scripts. A successful exploit could allow the attacker to trigger a heap overflow condition and execute arbitrary code with root privileges on the underlying Linux operating system of an affected device. |
| A vulnerability in the Sourcefire tunnel control channel protocol in Cisco Firepower System Software running on Cisco Firepower Threat Defense (FTD) sensors could allow an authenticated, local attacker to execute specific CLI commands with root privileges on the Cisco Firepower Management Center (FMC), or through Cisco FMC on other Firepower sensors and devices that are controlled by the same Cisco FMC. To send the commands, the attacker must have root privileges for at least one affected sensor or the Cisco FMC. The vulnerability exists because the affected software performs insufficient checks for certain CLI commands, if the commands are executed via a Sourcefire tunnel connection. An attacker could exploit this vulnerability by authenticating with root privileges to a Firepower sensor or Cisco FMC, and then sending specific CLI commands to the Cisco FMC or through the Cisco FMC to another Firepower sensor via the Sourcefire tunnel connection. A successful exploit could allow the attacker to modify device configurations or delete files on the device that is running Cisco FMC Software or on any Firepower device that is managed by Cisco FMC. |
| A vulnerability in the Server Message Block Version 2 (SMBv2) and Version 3 (SMBv3) protocol implementation for the Cisco Firepower System Software could allow an unauthenticated, remote attacker to cause the device to run low on system memory, possibly preventing the device from forwarding traffic. It is also possible that a manual reload of the device may be required to clear the condition. The vulnerability is due to incorrect SMB header validation. An attacker could exploit this vulnerability by sending a custom SMB file transfer through the targeted device. A successful exploit could cause the device to consume an excessive amount of system memory and prevent the SNORT process from forwarding network traffic. This vulnerability can be exploited using either IPv4 or IPv6 in combination with SMBv2 or SMBv3 network traffic. |
| A vulnerability in the cryptographic hardware accelerator driver of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a temporary denial of service (DoS) condition. The vulnerability exists because the affected devices have a limited amount of Direct Memory Access (DMA) memory and the affected software improperly handles resources in low-memory conditions. An attacker could exploit this vulnerability by sending a sustained, high rate of malicious traffic to an affected device to exhaust memory on the device. A successful exploit could allow the attacker to exhaust DMA memory on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the FTP inspection engine of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerability exists because the affected software fails to release spinlocks when a device is running low on system memory, if the software is configured to apply FTP inspection and an access control rule to transit traffic, and the access control rule is associated with an FTP file policy. An attacker could exploit this vulnerability by sending a high rate of transit traffic through an affected device to cause a low-memory condition on the device. A successful exploit could allow the attacker to cause a software panic on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the per-user-override feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass an access control list (ACL) that is configured for an interface of an affected device. The vulnerability is due to errors that could occur when the affected software constructs and applies per-user-override rules. An attacker could exploit this vulnerability by connecting to a network through an affected device that has a vulnerable configuration. A successful exploit could allow the attacker to access resources that are behind the affected device and would typically be protected by the interface ACL. |
| A vulnerability in the TCP syslog module of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to exhaust the 1550-byte buffers on an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to a missing boundary check in an internal function. An attacker could exploit this vulnerability by establishing a man-in-the-middle position between an affected device and its configured TCP syslog server and then maliciously modifying the TCP header in segments that are sent from the syslog server to the affected device. A successful exploit could allow the attacker to exhaust buffer on the affected device and cause all TCP-based features to stop functioning, resulting in a DoS condition. The affected TCP-based features include AnyConnect SSL VPN, clientless SSL VPN, and management connections such as Secure Shell (SSH), Telnet, and HTTPS. |
| A vulnerability in the Link Layer Discovery Protocol (LLDP) implementation for Cisco FXOS Software and Cisco NX-OS Software could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition when the device unexpectedly reloads. The vulnerability is due to improper input validation of certain type, length, value (TLV) fields of the LLDP frame header. An attacker could exploit this vulnerability by sending a crafted LLDP packet to an interface on the targeted device. A successful exploit could allow the attacker to cause the switch to reload unexpectedly. |
| A vulnerability in the Session Initiation Protocol (SIP) inspection engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload or trigger high CPU, resulting in a denial of service (DoS) condition. The vulnerability is due to improper handling of SIP traffic. An attacker could exploit this vulnerability by sending SIP requests designed to specifically trigger this issue at a high rate across an affected device. Software updates that address this vulnerability are not yet available. |
| A vulnerability in the detection engine of Cisco Firepower System Software could allow an unauthenticated, remote attacker to bypass a configured Intrusion Prevention System (IPS) rule that inspects certain types of TCP traffic. The vulnerability is due to incorrect TCP retransmission handling. An attacker could exploit this vulnerability by sending a crafted TCP connection request through an affected device. A successful exploit could allow the attacker to bypass configured IPS rules and allow uninspected traffic onto the network. |
| A vulnerability in the IP geolocation rules of Snort 3 could allow an unauthenticated, remote attacker to potentially bypass IP address restrictions. This vulnerability exists because the configuration for IP geolocation rules is not parsed properly. An attacker could exploit this vulnerability by spoofing an IP address until they bypass the restriction. A successful exploit could allow the attacker to bypass location-based IP address restrictions. |
| Multiple vulnerabilities in the per-user-override feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should be denied to flow through an affected device. These vulnerabilities are due to a logic error that could occur when the affected software constructs and applies per-user-override rules. An attacker could exploit these vulnerabilities by connecting to a network through an affected device that has a vulnerable configuration. A successful exploit could allow the attacker to bypass the interface ACL and access resources that would should be protected. |
