| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Cisco IOS 2.2(18)EW, 12.2(18)EWA, 12.2(14)SZ, 12.2(18)S, 12.2(18)SE, 12.2(18)SV, 12.2(18)SW, and other versions without the "no service dhcp" command, keep undeliverable DHCP packets in the queue instead of dropping them, which allows remote attackers to cause a denial of service (dropped traffic) via multiple undeliverable DHCP packets that exceed the input queue size. |
| The Service Assurance Agent (SAA) in Cisco IOS 12.0 through 12.2, aka Response Time Reporter (RTR), allows remote attackers to cause a denial of service (crash) via malformed RTR packets to port 1967. |
| The SSL/TLS handshaking code in OpenSSL 0.9.7a, 0.9.7b, and 0.9.7c, when using Kerberos ciphersuites, does not properly check the length of Kerberos tickets during a handshake, which allows remote attackers to cause a denial of service (crash) via a crafted SSL/TLS handshake that causes an out-of-bounds read. |
| Cisco Catalyst 2900 Virtual LAN (VLAN) switches allow remote attackers to inject 802.1q frames into another VLAN by forging the VLAN identifier in the trunking tag. |
| Buffer overflow in Cisco IOS 11.2.x to 12.0.x allows remote attackers to cause a denial of service and possibly execute commands via a large number of OSPF neighbor announcements. |
| Cisco IOS 11.x and 12.0 through 12.2 allows remote attackers to cause a denial of service (traffic block) by sending a particular sequence of IPv4 packets to an interface on the device, causing the input queue on that interface to be marked as full. |
| Cisco IOS 11.x and 12.0 with ATM support allows attackers to cause a denial of service via the undocumented Interim Local Management Interface (ILMI) SNMP community string. |
| Cisco IOS 12.2 and earlier running Cisco Discovery Protocol (CDP) allows remote attackers to cause a denial of service (memory consumption) via a flood of CDP neighbor announcements. |
| A vulnerability in the Simple Network Management Protocol (SNMP) subsystem of Cisco IOS XE Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper error handling when parsing a specific SNMP request. An attacker could exploit this vulnerability by sending a specific SNMP request to an affected device. A successful exploit could allow the attacker to cause the device to reload unexpectedly, resulting in a DoS condition.
This vulnerability affects SNMP versions 1, 2c, and 3. To exploit this vulnerability through SNMPv2c or earlier, the attacker must know a valid read-write or read-only SNMP community string for the affected system. To exploit this vulnerability through SNMPv3, the attacker must have valid SNMP user credentials for the affected system. |
| Multiple vulnerabilities in Cisco IOS XE Software of could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to the device to execute persistent code at boot time and break the chain of trust.
These vulnerabilities are due path traversal and improper image integrity validation. A successful exploit could allow the attacker to execute persistent code on the underlying operating system.
Because this allows the attacker to bypass a major security feature of the device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High.
For more information about these vulnerabilities, see the Details ["#details"] section of this advisory.
ERP |
| A vulnerability in the HTTP API subsystem of Cisco IOS XE Software could allow a remote attacker to inject commands that will execute with root privileges into the underlying operating system.
This vulnerability is due to insufficient input validation. An attacker with administrative privileges could exploit this vulnerability by authenticating to an affected system and performing an API call with crafted input. Alternatively, an unauthenticated attacker could persuade a legitimate user with administrative privileges who is currently logged in to the system to click a crafted link. A successful exploit could allow the attacker to execute arbitrary commands as the root user. |
| A vulnerability in the IKEv2 feature of Cisco IOS Software, IOS XE Software, Secure Firewall ASA Software, and Secure FTD Software could allow an unauthenticated, remote attacker to cause the device to reload, resulting in a DoS condition.
This vulnerability is due to the improper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. A successful exploit could allow the attacker to cause an infinite loop that exhausts resources and could cause the device to reload. |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) feature of Cisco IOS Software, IOS XE Software, Secure Firewall Adaptive Security Appliance (ASA) Software, and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to a lack of proper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. In the case of Cisco IOS and IOS XE Software, a successful exploit could allow the attacker to cause the device to reload unexpectedly. In the case of Cisco ASA and FTD Software, a successful exploit could allow the attacker to partially exhaust system memory, causing system instability such as being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| A vulnerability in the Network-Based Application Recognition (NBAR) feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload, causing a denial of service (DoS) condition.
This vulnerability is due to improper handling of malformed Control and Provisioning of Wireless Access Points (CAPWAP) packets. An attacker could exploit this vulnerability by sending malformed CAPWAP packets through an affected device. A successful exploit could allow the attacker to cause the device to reload unexpectedly, resulting in a DoS condition. |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) feature of Cisco IOS Software, IOS XE Software, Secure Firewall Adaptive Security Appliance (ASA) Software, and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to a lack of proper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. In the case of Cisco IOS and IOS XE Software, a successful exploit could allow the attacker to cause the device to reload unexpectedly. In the case of Cisco ASA and FTD Software, a successful exploit could allow the attacker to partially exhaust system memory, causing system instability such as being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| A vulnerability in the Day One setup process of Cisco IOS XE Software for Catalyst 9800 Series Wireless Controllers for Cloud (9800-CL) could allow an unauthenticated, remote attacker to access the public-key infrastructure (PKI) server that is running on an affected device.
This vulnerability is due to incomplete cleanup upon completion of the Day One setup process. An attacker could exploit this vulnerability by sending Simple Certificate Enrollment Protocol (SCEP) requests to an affected device. A successful exploit could allow the attacker to request a certificate from the virtual wireless controller and then use the acquired certificate to join an attacker-controlled device to the virtual wireless controller. |
| A vulnerability in the Address Resolution Protocol (ARP) implementation of Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to trigger a broadcast storm, leading to a denial of service (DoS) condition on an affected device.
This vulnerability is due to how Cisco IOS XR Software processes a high, sustained rate of ARP traffic hitting the management interface. Under certain conditions, an attacker could exploit this vulnerability by sending an excessive amount of traffic to the management interface of an affected device, overwhelming its ARP processing capabilities. A successful exploit could result in degraded device performance, loss of management connectivity, and complete unresponsiveness of the system, leading to a DoS condition. |
| A vulnerability in the access control list (ACL) programming of Cisco IOS XE Software for Cisco Catalyst 9500X and 9600X Series Switches could allow an unauthenticated, remote attacker to bypass a configured ACL on an affected device.
This vulnerability is due to the flooding of traffic from an unlearned MAC address on a switch virtual interface (SVI) that has an egress ACL applied. An attacker could exploit this vulnerability by causing the VLAN to flush its MAC address table. This condition can also occur if the MAC address table is full. A successful exploit could allow the attacker to bypass an egress ACL on an affected device. |
| A vulnerability in the handling of certain Ethernet frames in Cisco IOS XE Software for Catalyst 9000 Series Switches could allow an unauthenticated, adjacent attacker to cause an egress port to become blocked and drop all outbound traffic.
This vulnerability is due to improper handling of crafted Ethernet frames. An attacker could exploit this vulnerability by sending crafted Ethernet frames through an affected switch. A successful exploit could allow the attacker to cause the egress port to which the crafted frame is forwarded to start dropping all frames, resulting in a denial of service (DoS) condition. |
| A vulnerability in the Layer 2 Ethernet services of Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to cause the line card network processor to reset, resulting in a denial of service (DoS) condition.
This vulnerability is due to the incorrect handling of specific Ethernet frames that are received on line cards that have the Layer 2 services feature enabled. An attacker could exploit this vulnerability by sending specific Ethernet frames through an affected device. A successful exploit could allow the attacker to cause the ingress interface network processor to reset, resulting in a loss of traffic over the interfaces that are supported by the network processor. Multiple resets of the network processor would cause the line card to reset, resulting in a DoS condition. |
