| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ufs: core: tracing: Do not dereference pointers in TP_printk()
The trace events in drivers/ufs/core/ufs_trace.h were converted to take a
pointer to the hba structure as an argument for the tracepoint and then in
TP_printk() the printing of the dev_name from the ring buffer was
converted to using the dev dereferenced pointer from the hba saved
pointer.
This is not allowed as the TP_printk() is executed at the time the trace
event is read from /sys/kernel/tracing/trace file. That can happen
literally, seconds, minutes, hours, weeks, days, or even months later!
There is no guarantee that the hba pointer will still exist by the time it
is dereferenced when the "trace" file is read.
Instead, save the device name from the hba pointer at the time the
tracepoint is called and place it into the ring buffer event. Then the
TP_printk() can read the name directly from the ring buffer and remove the
possibility that it will read a freed pointer and crash the kernel.
This was detected when testing the trace event code that looks for
TP_printk() parameters doing illegal derferences[1]
[1] https://lore.kernel.org/all/20260630184836.74d477b6@gandalf.local.home/ |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_nat: reject unsupported target families
xt_nat SNAT and DNAT target handlers assume IP-family conntrack state
is present and can dereference a NULL pointer when instantiated from an
unsupported family through nft_compat. A bridge-family compat rule can
therefore trigger a NULL-dereference in nf_nat_setup_info().
Reject non-IP families in xt_nat_checkentry() so unsupported targets
cannot be installed. Keep NFPROTO_INET allowed for valid inet NAT
compat users and leave the runtime fast path unchanged.
[ The crash was fixed via
9dbba7e694ec ("netfilter: nft_compat: ebtables emulation must reject non-bridge targets"),
so this patch is no longer critical.
Nevertheless, NAT is only relevant for ipv4/ipv6, so this extra
family check is a good idea in any case. ] |
| In Zimbra Collaboration (ZCS) before 10.1.17, weak cryptographic key generation vulnerability exists in the OnlyOffice integration. The zimbraDocumentEditingJwtSecret is generated using an insecure random number generator, resulting in insufficient entropy. An attacker who obtains a JWT signed with the generated secret may be able to recover the JWT signing secret through offline brute-force, potentially enabling JWT forgery. |
| This CVE ID was assigned to a reported vulnerability in the Customer Reviews for WooCommerce WordPress plugin and was never published. The report was withdrawn: the precondition it depends on, an attacker obtaining a review form identifier belonging to a customer they do not already have access to, could not be demonstrated. No advisory was issued for this ID. |
| In the Linux kernel, the following vulnerability has been resolved:
libbpf: Reject non-exclusive metadata maps in the signed loader
The loader verifies map->sha against the metadata hash in its
instructions. map->sha is calculated when BPF_OBJ_GET_INFO_BY_FD is
called on the frozen map.
While the map is frozen, the /signed loader/ must also ensure the map
is exclusive, as, without exclusivity (which a hostile host could just
omit when loading the loader), another BPF program with map access can
mutate the contents afterwards, so the check passes on stale data.
With the extra check as part of the signed loader, it now refuses to
move on with map->sha validation if the host set it up wrongly. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: use proper context for logging
The same as the rest of the code, get_ss_info_from_atombios() uses
calc_pll_cs->ctx->logger for logging. But calc_pll_cs->ctx is
initialized only later in calc_pll_max_vco_construct(). Therefore, any
output using DC_LOG_SYNC() leads to a NULL pointer deference in
get_ss_info_from_atombios().
According to Sashiko, the very same problem exists in
dce112_get_pix_clk_dividers() and dcn3_get_pix_clk_dividers() too.
To avoid accessing the NULL context, use clk_src->base.ctx->logger
everywhere. That context in base is initialized earlier in
dce110_clk_src_construct() and dce112_clk_src_construct(). Before
get_ss_info_from_atombios() or Sashiko's get_pix_clk_dividers functions
above are actually called. This is done by redefining DC_LOGGER to
CTX->logger.
Before:
dce110_clk_src_construct() did:
-> sets clk_src->base.ctx = ctx;
-> ss_info_from_atombios_create()
-> get_ss_info_from_atombios() <- uses calc_pll_cs->ctx # BOOM
-> calc_pll_max_vco_construct() <- sets calc_pll_cs->ctx
After:
dce110_clk_src_construct() does:
-> sets clk_src->base.ctx = ctx;
-> ss_info_from_atombios_create()
-> get_ss_info_from_atombios() <- uses clk_src->base.ctx
(cherry picked from commit 6f16fcbb0c46a87e3d9685407e906573d60104b0) |
| In the Linux kernel, the following vulnerability has been resolved:
s390/dasd: Fix undersized format-check buffer
fmt_buffer_size in dasd_eckd_check_device_format() is declared as
int, even though one of the multiplicands, sizeof(struct eckd_count),
is a size_t. The expression
trkcount * rpt_max * sizeof(struct eckd_count)
is therefore correctly evaluated at 64-bit width, but the result is
silently truncated when it is stored back into the 32-bit
fmt_buffer_size variable. For a sufficiently large track range
(start_unit/stop_unit are caller-controlled) this truncation
yields a buffer size far smaller than the number of tracks actually
requested. kzalloc() then succeeds with an undersized allocation,
while the subsequent channel program build still operates on the
untruncated track count and writes past the end of that buffer.
Compute the buffer size with check_mul_overflow() and keep it in a
size_t, so that a value that no longer fits results in -EINVAL
instead of a silently truncated allocation size. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: spi-qpic-snand: write the feature value before executing SET_FEATURE
qcom_spi_send_cmdaddr() programs NAND_FLASH_CMD/NAND_EXEC_CMD and submits
the descriptors, which makes the controller execute the command
immediately. For SPINAND_SET_FEATURE the value to be written is only
placed into NAND_FLASH_FEATURES afterwards, by qcom_spi_io_op(), in a
second submission - so the chip is programmed with whatever that register
happened to hold from a previous operation, and the intended value is only
applied by the *next* SET_FEATURE.
Measured on a TP-Link Archer AX55 v1 (IPQ5018, ESMT F50L1G41LB): writing
0x40 to the configuration register (0xb0) leaves the chip at 0x00, and the
subsequent write of 0x00 leaves it at 0x40 - every write lands one
operation late.
This stayed unnoticed until v6.18 added SPI-NAND OTP support together
with OTP entries for ESMT chips. spinand_otp_rw() enables OTP mode,
reads, and disables it again, and mtd_otp_nvmem_add() does this during
MTD registration. With the off-by-one, the "disable" write actually
applies the previously requested value, so CFG_OTP_ENABLE ends up set:
the chip stays in OTP mode, every subsequent array read returns the OTP
area instead of the array (UBI reports an empty device) and all writes
fail with -EIO because the OTP area is write protected. On this board
that makes the whole flash unusable and the device unbootable.
Write the feature value into NAND_FLASH_FEATURES as part of the same
transaction, before NAND_EXEC_CMD. While at it, copy only the bytes the
operation actually carries - the previous code dereferenced a 4-byte
pointer on a one-byte buffer (spinand->scratchbuf).
With this patch the flash contents read back bit-identical to a
known-good dump of the same board taken under the vendor firmware
(md5-verified across partitions), and writes work. |
| In the Linux kernel, the following vulnerability has been resolved:
io_uring: preserve task restrictions across exec
Per-task restrictions apply to all rings created by a task. Once
installed, they should not be dropped across exec.
For a task that has used io_uring, the exec cancellation path calls
__io_uring_free(). This frees both the task context and the per-task
restriction, so a ring created after exec is unrestricted.
Split task context cleanup into io_uring_free_tctx(), and use it from
the exec cancellation path. Keep __io_uring_free() for final task
cleanup, where both the context and restriction are released. |
| In the Linux kernel, the following vulnerability has been resolved:
sctp: validate Adaptation Indication parameter length
The Adaptation Layer Indication parameter contains a fixed 32-bit
Adaptation Code Point after its parameter header. However,
sctp_verify_param() accepts a header-only parameter because the generic
parameter walker only requires the header to be present.
sctp_process_param() then reads adaptation_ind beyond the declared
parameter. When the malformed parameter is last in an INIT, the read
starts at the receive skb tail, and the value is copied into the state
cookie returned in the INIT ACK. This may disclose four receive-buffer
tail bytes.
Require the declared parameter length to match the fixed structure size
and abort the association through the existing invalid parameter length
path otherwise. |
| A server-ide request forgery (SSRF) vulnerability in webhook in Synology Chat Server before 2.4.5-22148 allows remote authenticated users to obtain non-sensitive information. |
| The Tutor LMS WordPress plugin before 4.0.6 does not prevent request data from overwriting internal variables while rendering templates, allowing unauthenticated users to invoke arbitrary zero-argument PHP functions and receive their output. |
| The User Frontend WordPress plugin before 4.3.10 does not properly validate field type definitions and deserialises user-controlled post metadata when rendering submitted posts, allowing users with Editor-level access and above to inject arbitrary PHP objects, which can lead to remote code execution when a suitable POP chain is present on the site. |
| CodeChecker's massStoreRun processing path performs one-shot decompression of attacker-controlled, Base64-encoded zlib data without enforcing a maximum decompressed size.
An authenticated user with permission to store analysis runs can submit a highly compressed payload that expands to a significantly larger byte sequence. Because the entire decompressed output is materialized in memory before being written to a temporary file, a sufficiently large payload may exhaust process or host memory and consume substantial disk space, resulting in denial of service. |
| The Quiz and Survey Master (QSM) WordPress plugin before 11.2.4 does not check authorisation when returning question bank entries through one of its REST API routes, allowing users with a role as low as Contributor to read the questions, hints and correct answer keys of quizzes belonging to other users. |
| The User Registration & Membership WordPress plugin before 5.2.5 does not verify that the account whose pending email change is being cancelled belongs to the user making the request, allowing authenticated users with Subscriber-level access and above to cancel any other user's in-progress email change, including an administrator's. |
| CVE-2025-40843 https://github.com/advisories/GHSA-5xf2-f6ch-6p8r was fixed by replacing unchecked strcpy() with a bounded safe_strcpy() helper.
At ldlogger-tool-gcc.c:129 the destination passed to that helper is fullPath + 2, but the size
passed down is the full PATH_MAX. safe_strcpy() is strncpy(), which NUL-pads the
destination out to the whole n, so this site writes 4096 bytes into the 4094 that remain — a
2-byte stack overflow on every invocation, independent of the input path's length.
This issue affects CodeChecker: through 6.28.2. |
| In the Linux kernel, the following vulnerability has been resolved:
vxlan: re-fetch eth header after route_shortcircuit()
Before route_shortcircuit(), the eth header pointer is cached from eth_hdr(skb).
Inside route_shortcircuit(), pskb_may_pull() can be called, which may
reallocate skb->head.
In this case, returning to vxlan_xmit() leaves the cached eth pointer pointing to
freed memory, leading to a use-after-free when dereferencing eth->h_dest.
Fix this by updating eth = eth_hdr(skb) after calling route_shortcircuit(). |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: pci: Fix NULL dereference on AIBV allocation failure
The airq_iv_create() can return NULL on failure, but the return value was
never checked. If it fails, zdev->aibv will be NULL and fail when
dereferenced in kvm_zpci_set_airq(). Add a NULL check and free the
previously allocated AISB bit and zdev->aisb on failure. |
| An attacker that can send mail to a user can craft a message whose headers contain a very large number of email addresses or MIME parameters, which causes excessive memory usage when the message is later parsed. The message is still delivered, but reading it over IMAP can exhaust the memory limit of the process and terminate it, causing denial of service for the affected user. Update to non-vulnerable version. No publicly available exploits are known. |
