| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
tty: n_gsm: Don't block input queue by waiting MSC
Currently gsm_queue() processes incoming frames and when opening
a DLC channel it calls gsm_dlci_open() which calls gsm_modem_update().
If basic mode is used it calls gsm_modem_upd_via_msc() and it
cannot block the input queue by waiting the response to come
into the same input queue.
Instead allow sending Modem Status Command without waiting for remote
end to respond. Define a new function gsm_modem_send_initial_msc()
for this purpose. As MSC is only valid for basic encoding, it does
not do anything for advanced or when convergence layer type 2 is used. |
| In the Linux kernel, the following vulnerability has been resolved:
accel/qaic: Fix bootlog initialization ordering
As soon as we queue MHI buffers to receive the bootlog from the device,
we could be receiving data. Therefore all the resources needed to
process that data need to be setup prior to queuing the buffers.
We currently initialize some of the resources after queuing the buffers
which creates a race between the probe() and any data that comes back
from the device. If the uninitialized resources are accessed, we could
see page faults.
Fix the init ordering to close the race. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: transport_ipc: validate payload size before reading handle
handle_response() dereferences the payload as a 4-byte handle without
verifying that the declared payload size is at least 4 bytes. A malformed
or truncated message from ksmbd.mountd can lead to a 4-byte read past the
declared payload size. Validate the size before dereferencing.
This is a minimal fix to guard the initial handle read. |
| In the Linux kernel, the following vulnerability has been resolved:
nvmet-fc: move lsop put work to nvmet_fc_ls_req_op
It’s possible for more than one async command to be in flight from
__nvmet_fc_send_ls_req. For each command, a tgtport reference is taken.
In the current code, only one put work item is queued at a time, which
results in a leaked reference.
To fix this, move the work item to the nvmet_fc_ls_req_op struct, which
already tracks all resources related to the command. |
| In the Linux kernel, the following vulnerability has been resolved:
net: use dst_dev_rcu() in sk_setup_caps()
Use RCU to protect accesses to dst->dev from sk_setup_caps()
and sk_dst_gso_max_size().
Also use dst_dev_rcu() in ip6_dst_mtu_maybe_forward(),
and ip_dst_mtu_maybe_forward().
ip4_dst_hoplimit() can use dst_dev_net_rcu(). |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Fix NULL pointer deference in try_to_register_card
In try_to_register_card(), the return value of usb_ifnum_to_if() is
passed directly to usb_interface_claimed() without a NULL check, which
will lead to a NULL pointer dereference when creating an invalid
USB audio device. Fix this by adding a check to ensure the interface
pointer is valid before passing it to usb_interface_claimed(). |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_ecm: Refactor bind path to use __free()
After an bind/unbind cycle, the ecm->notify_req is left stale. If a
subsequent bind fails, the unified error label attempts to free this
stale request, leading to a NULL pointer dereference when accessing
ep->ops->free_request.
Refactor the error handling in the bind path to use the __free()
automatic cleanup mechanism. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_rndis: Refactor bind path to use __free()
After an bind/unbind cycle, the rndis->notify_req is left stale. If a
subsequent bind fails, the unified error label attempts to free this
stale request, leading to a NULL pointer dereference when accessing
ep->ops->free_request.
Refactor the error handling in the bind path to use the __free()
automatic cleanup mechanism. |
| In the Linux kernel, the following vulnerability has been resolved:
tty: serial: samsung_tty: Fix a memory leak in s3c24xx_serial_getclk() in case of error
If clk_get_rate() fails, the clk that has just been allocated needs to be
freed. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: hda: cs35l41: Fix NULL pointer dereference in cs35l41_get_acpi_mute_state()
Return value of a function acpi_evaluate_dsm() is dereferenced without
checking for NULL, but it is usually checked for this function.
acpi_evaluate_dsm() may return NULL, when acpi_evaluate_object() returns
acpi_status other than ACPI_SUCCESS, so add a check to prevent the crach.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: use RCU in ip6_output()
Use RCU in ip6_output() in order to use dst_dev_rcu() to prevent
possible UAF.
We can remove rcu_read_lock()/rcu_read_unlock() pairs
from ip6_finish_output2(). |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: use RCU in ip6_xmit()
Use RCU in ip6_xmit() in order to use dst_dev_rcu() to prevent
possible UAF. |
| In the Linux kernel, the following vulnerability has been resolved:
mptcp: Use __sk_dst_get() and dst_dev_rcu() in mptcp_active_enable().
mptcp_active_enable() is called from subflow_finish_connect(),
which is icsk->icsk_af_ops->sk_rx_dst_set() and it's not always
under RCU.
Using sk_dst_get(sk)->dev could trigger UAF.
Let's use __sk_dst_get() and dst_dev_rcu(). |
| In the Linux kernel, the following vulnerability has been resolved:
sparc: fix accurate exception reporting in copy_{from_to}_user for Niagara
The referenced commit introduced exception handlers on user-space memory
references in copy_from_user and copy_to_user. These handlers return from
the respective function and calculate the remaining bytes left to copy
using the current register contents. This commit fixes a couple of bad
calculations and a broken epilogue in the exception handlers. This will
prevent crashes and ensure correct return values of copy_from_user and
copy_to_user in the faulting case. The behaviour of memcpy stays unchanged. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix memory leaks when rejecting a non SINGLE data profile without an RST
At the end of btrfs_load_block_group_zone_info() the first thing we do
is to ensure that if the mapping type is not a SINGLE one and there is
no RAID stripe tree, then we return early with an error.
Doing that, though, prevents the code from running the last calls from
this function which are about freeing memory allocated during its
run. Hence, in this case, instead of returning early, we set the ret
value and fall through the rest of the cleanup code. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: relax BUG() to ocfs2_error() in __ocfs2_move_extent()
In '__ocfs2_move_extent()', relax 'BUG()' to 'ocfs2_error()' just
to avoid crashing the whole kernel due to a filesystem corruption. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: rng - Ensure set_ent is always present
Ensure that set_ent is always set since only drbg provides it. |
| In the Linux kernel, the following vulnerability has been resolved:
io_uring/net: ensure vectored buffer node import is tied to notification
When support for vectored registered buffers was added, the import
itself is using 'req' rather than the notification io_kiocb, sr->notif.
For non-vectored imports, sr->notif is correctly used. This is important
as the lifetime of the two may be different. Use the correct io_kiocb
for the vectored buffer import. |
| In the Linux kernel, the following vulnerability has been resolved:
MIPS: fw: Allow firmware to pass a empty env
fw_getenv will use env entry to determine style of env,
however it is legal for firmware to just pass a empty list.
Check if first entry exist before running strchr to avoid
null pointer dereference. |
| In the Linux kernel, the following vulnerability has been resolved:
blk-cgroup: Fix NULL deref caused by blkg_policy_data being installed before init
blk-iocost sometimes causes the following crash:
BUG: kernel NULL pointer dereference, address: 00000000000000e0
...
RIP: 0010:_raw_spin_lock+0x17/0x30
Code: be 01 02 00 00 e8 79 38 39 ff 31 d2 89 d0 5d c3 0f 1f 00 0f 1f 44 00 00 55 48 89 e5 65 ff 05 48 d0 34 7e b9 01 00 00 00 31 c0 <f0> 0f b1 0f 75 02 5d c3 89 c6 e8 ea 04 00 00 5d c3 0f 1f 84 00 00
RSP: 0018:ffffc900023b3d40 EFLAGS: 00010046
RAX: 0000000000000000 RBX: 00000000000000e0 RCX: 0000000000000001
RDX: ffffc900023b3d20 RSI: ffffc900023b3cf0 RDI: 00000000000000e0
RBP: ffffc900023b3d40 R08: ffffc900023b3c10 R09: 0000000000000003
R10: 0000000000000064 R11: 000000000000000a R12: ffff888102337000
R13: fffffffffffffff2 R14: ffff88810af408c8 R15: ffff8881070c3600
FS: 00007faaaf364fc0(0000) GS:ffff88842fdc0000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: 00000000000000e0 CR3: 00000001097b1000 CR4: 0000000000350ea0
Call Trace:
<TASK>
ioc_weight_write+0x13d/0x410
cgroup_file_write+0x7a/0x130
kernfs_fop_write_iter+0xf5/0x170
vfs_write+0x298/0x370
ksys_write+0x5f/0xb0
__x64_sys_write+0x1b/0x20
do_syscall_64+0x3d/0x80
entry_SYSCALL_64_after_hwframe+0x46/0xb0
This happens because iocg->ioc is NULL. The field is initialized by
ioc_pd_init() and never cleared. The NULL deref is caused by
blkcg_activate_policy() installing blkg_policy_data before initializing it.
blkcg_activate_policy() was doing the following:
1. Allocate pd's for all existing blkg's and install them in blkg->pd[].
2. Initialize all pd's.
3. Online all pd's.
blkcg_activate_policy() only grabs the queue_lock and may release and
re-acquire the lock as allocation may need to sleep. ioc_weight_write()
grabs blkcg->lock and iterates all its blkg's. The two can race and if
ioc_weight_write() runs during #1 or between #1 and #2, it can encounter a
pd which is not initialized yet, leading to crash.
The crash can be reproduced with the following script:
#!/bin/bash
echo +io > /sys/fs/cgroup/cgroup.subtree_control
systemd-run --unit touch-sda --scope dd if=/dev/sda of=/dev/null bs=1M count=1 iflag=direct
echo 100 > /sys/fs/cgroup/system.slice/io.weight
bash -c "echo '8:0 enable=1' > /sys/fs/cgroup/io.cost.qos" &
sleep .2
echo 100 > /sys/fs/cgroup/system.slice/io.weight
with the following patch applied:
> diff --git a/block/blk-cgroup.c b/block/blk-cgroup.c
> index fc49be622e05..38d671d5e10c 100644
> --- a/block/blk-cgroup.c
> +++ b/block/blk-cgroup.c
> @@ -1553,6 +1553,12 @@ int blkcg_activate_policy(struct gendisk *disk, const struct blkcg_policy *pol)
> pd->online = false;
> }
>
> + if (system_state == SYSTEM_RUNNING) {
> + spin_unlock_irq(&q->queue_lock);
> + ssleep(1);
> + spin_lock_irq(&q->queue_lock);
> + }
> +
> /* all allocated, init in the same order */
> if (pol->pd_init_fn)
> list_for_each_entry_reverse(blkg, &q->blkg_list, q_node)
I don't see a reason why all pd's should be allocated, initialized and
onlined together. The only ordering requirement is that parent blkgs to be
initialized and onlined before children, which is guaranteed from the
walking order. Let's fix the bug by allocating, initializing and onlining pd
for each blkg and holding blkcg->lock over initialization and onlining. This
ensures that an installed blkg is always fully initialized and onlined
removing the the race window. |
