In the Linux kernel, the following vulnerability has been resolved:
ipv6: icmp: clear skb2->cb[] in ip6_err_gen_icmpv6_unreach()
Sashiko AI-review observed:
In ip6_err_gen_icmpv6_unreach(), the skb is an outer IPv4 ICMP error packet
where its cb contains an IPv4 inet_skb_parm. When skb is cloned into skb2
and passed to icmp6_send(), it uses IP6CB(skb2).
IP6CB interprets the IPv4 inet_skb_parm as an inet6_skb_parm. The cipso
offset in inet_skb_parm.opt directly overlaps with dsthao in inet6_skb_parm
at offset 18.
If an attacker sends a forged ICMPv4 error with a CIPSO IP option, dsthao
would be a non-zero offset. Inside icmp6_send(), mip6_addr_swap() is called
and uses ipv6_find_tlv(skb, opt->dsthao, IPV6_TLV_HAO).
This would scan the inner, attacker-controlled IPv6 packet starting at that
offset, potentially returning a fake TLV without checking if the remaining
packet length can hold the full 18-byte struct ipv6_destopt_hao.
Could mip6_addr_swap() then perform a 16-byte swap that extends past the end
of the packet data into skb_shared_info?
Should the cb array also be cleared in ip6_err_gen_icmpv6_unreach() and
ip6ip6_err() to prevent this?
This patch implements the first suggestion.
I am not sure if ip6ip6_err() needs to be changed.
A separate patch would be better anyway.
ipv6: icmp: clear skb2->cb[] in ip6_err_gen_icmpv6_unreach()
Sashiko AI-review observed:
In ip6_err_gen_icmpv6_unreach(), the skb is an outer IPv4 ICMP error packet
where its cb contains an IPv4 inet_skb_parm. When skb is cloned into skb2
and passed to icmp6_send(), it uses IP6CB(skb2).
IP6CB interprets the IPv4 inet_skb_parm as an inet6_skb_parm. The cipso
offset in inet_skb_parm.opt directly overlaps with dsthao in inet6_skb_parm
at offset 18.
If an attacker sends a forged ICMPv4 error with a CIPSO IP option, dsthao
would be a non-zero offset. Inside icmp6_send(), mip6_addr_swap() is called
and uses ipv6_find_tlv(skb, opt->dsthao, IPV6_TLV_HAO).
This would scan the inner, attacker-controlled IPv6 packet starting at that
offset, potentially returning a fake TLV without checking if the remaining
packet length can hold the full 18-byte struct ipv6_destopt_hao.
Could mip6_addr_swap() then perform a 16-byte swap that extends past the end
of the packet data into skb_shared_info?
Should the cb array also be cleared in ip6_err_gen_icmpv6_unreach() and
ip6ip6_err() to prevent this?
This patch implements the first suggestion.
I am not sure if ip6ip6_err() needs to be changed.
A separate patch would be better anyway.
Default status is the baseline for the product, each version can override it (e.g. patched versions marked unaffected).
| Vendor | Product | Default status | Versions | |||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Linux | Linux | unaffected |
|
|||||||||||||||||||||||||||||||||
| Linux | Linux | affected |
|
No data.
No data.
No data.
Advisories
No advisories yet.
Fixes
Solution
No solution given by the vendor.
Workaround
No workaround given by the vendor.
References
History
Fri, 01 May 2026 14:45:00 +0000
| Type | Values Removed | Values Added |
|---|---|---|
| Description | In the Linux kernel, the following vulnerability has been resolved: ipv6: icmp: clear skb2->cb[] in ip6_err_gen_icmpv6_unreach() Sashiko AI-review observed: In ip6_err_gen_icmpv6_unreach(), the skb is an outer IPv4 ICMP error packet where its cb contains an IPv4 inet_skb_parm. When skb is cloned into skb2 and passed to icmp6_send(), it uses IP6CB(skb2). IP6CB interprets the IPv4 inet_skb_parm as an inet6_skb_parm. The cipso offset in inet_skb_parm.opt directly overlaps with dsthao in inet6_skb_parm at offset 18. If an attacker sends a forged ICMPv4 error with a CIPSO IP option, dsthao would be a non-zero offset. Inside icmp6_send(), mip6_addr_swap() is called and uses ipv6_find_tlv(skb, opt->dsthao, IPV6_TLV_HAO). This would scan the inner, attacker-controlled IPv6 packet starting at that offset, potentially returning a fake TLV without checking if the remaining packet length can hold the full 18-byte struct ipv6_destopt_hao. Could mip6_addr_swap() then perform a 16-byte swap that extends past the end of the packet data into skb_shared_info? Should the cb array also be cleared in ip6_err_gen_icmpv6_unreach() and ip6ip6_err() to prevent this? This patch implements the first suggestion. I am not sure if ip6ip6_err() needs to be changed. A separate patch would be better anyway. | |
| Title | ipv6: icmp: clear skb2->cb[] in ip6_err_gen_icmpv6_unreach() | |
| First Time appeared |
Linux
Linux linux Kernel |
|
| CPEs | cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:* | |
| Vendors & Products |
Linux
Linux linux Kernel |
|
| References |
|
|
Projects
Sign in to view the affected projects.
MITRE
Status: PUBLISHED
Assigner: Linux
Published:
Updated: 2026-05-01T14:15:35.986Z
Reserved: 2026-05-01T14:12:55.978Z
Link: CVE-2026-43038
Vulnrichment
No data.
NVD
Status : Awaiting Analysis
Published: 2026-05-01T15:16:48.533
Modified: 2026-05-01T15:24:14.893
Link: CVE-2026-43038
Redhat
No data.
OpenCVE Enrichment
No data.
Weaknesses
No weakness.